Setting the rental price of your paddleboards: the step-by-step method
Costs, minimum price, rate by duration, season, clientele, compulsory display: the step-by-step method for setting the rental price…

End of season. The boards come into the storeroom still damp, the life jackets dry on a fence, a paddle keeps sand in its joint. Whether you manage a rental fleet or a single board, what you do now decides the state of the equipment in spring.
Here is the winter storage and maintenance routine, based on manufacturers’ manuals and guides and official texts. Figures vary from one manual to another: the one for your equipment always takes precedence.
Abrasives, sand and salt can age the board before its time, warns a maintenance guide. Hence four steps:
An inflatable board can spend the winter inflated or deflated, a manual states. The PSI (pounds per square inch) is the unit on the pump’s pressure gauge.
| Storage | Instructions noted |
|---|---|
| Inflated | Lower the pressure to about 8 PSI, stand the board against a wall or lay it flat on the floor (one guide); in the shade, below 50% of maximum pressure (one manual) |
| Rolled | Roll from the end opposite the valve, valve open, then close the valve so that neither mould nor debris gets in; loosely tightened strap; fold along the dotted lines if there are any |
| In both cases | Clean, dry, ventilated place; no hanging, discouraged by one manual; outdoors, off the ground and under a tarp |
To choose the location, see our article on storing water sports equipment by the water.
The paddle. A manual asks you to drain the water left in the shaft after each use. If it has a clamp, the same manual says to tighten it to reduce play: check it during winter storage.
The leash, the cord that links you to the board. A manufacturer’s guide advises you to:
The 24-hour test. Two manuals ask you to check that an inflated board holds its pressure for 24 hours, one before use, the other before a long journey. Do this test before the season: a drop that the cold does not explain calls for a check.
The valve first. A manual advises spraying soapy water around the valve: bubbles show the leak. Then tighten the valve with the wrench from the repair kit, never removing it while the board is inflated. To remove it, another manual requires a fully deflated board, then a rubber seal that is properly seated and clean.
The glued seams. A manual asks you to check regularly for cracks and warns that long storage can damage the glue.
The patch. Both manuals describe the same method, with different figures:
| Step | Manual A | Manual B |
|---|---|---|
| Conditions | 18 to 25 °C, humidity below 60%, no rain or direct sun, board deflated and flat | Board not inflated |
| Cleaning | Alcohol-based degreaser | Acetone or methyl ethyl ketone |
| Patch overlap | At least 5 cm | About 2.5 cm |
| Glue | 3 thin coats on the board and the patch, 5 minutes between each | On the board and the patch, 5 minutes of drying |
| Drying | About 12 hours | 24 hours before use |
Work in a ventilated area. Before repairing, read the warranty: manual B voids it after an unauthorised repair, and both exclude use for rental.
The French Sports Code refers drowning-prevention life jackets to the Labour Code rules on personal protective equipment (PPE). Go through them:
Operators: the Labour Code makes the person responsible for renting or repeatedly making available a used PPE responsible for keeping it compliant, notably by following the manual. An order of 22 October 2009 requires a management record for each item (reference, manual, purchase or commissioning date, planned scrapping date if it is subject to ageing, inspections, repairs, incidents, hygiene), kept for three years after scrapping or removal from stock. To choose the life jacket according to where you sail, see paddle regulations at sea.
Not necessarily: a manual says it can be stored inflated or deflated. Inflated, a guide advises lowering the pressure to about 8 PSI; rolled, keep a loosely tightened strap and close the valve.
Not if it freezes: a manual sets a range of 0 °C to 40 °C. If the board has been below 0 °C, another manual asks for about 12 hours at 20 °C before unfolding it.
Its marking is still legible and the expiry date or period given in the manual has not passed. Straps, buckles, fastenings and fabric are intact. At the slightest doubt, replace it.
Inflate the board to the stated pressure and check that it holds it for 24 hours. If the pressure drops without the cold explaining it, spray soapy water around the valve: bubbles show the leak.
Note these checks in your season preparation checklist and in the off-season calendar. In summer, the day’s equipment can stay locked up by the water in Wave-Up’s connected water sports equipment locker: 8 spaces for stand up paddle or surf boards, 8 lockers for life jacket, leash and waterproof pouch, 8 clips for the paddles. Request a quote: free, no commitment, reply within 24 working hours.

Costs, minimum price, rate by duration, season, clientele, compulsory display: the step-by-step method for setting the rental price…
The French sports code requires a qualification only to supervise for payment, not to rent. The obligations that remain, the reinstated declaration…
Salt, sun, humidity, theft: the solutions for storing water sports equipment by the water, their limits, the occupation rules of a…
Estimate the revenue of a self-service rental station on your site, then request your free quote.